Help

Help›Tightly Connect›Sell-out forecast accuracy

Sell-out forecast accuracy

Reviewed Oct 29, 2026

View as Markdown
Words

What it is ​

These scores apply to the sell-out engine and reported consumer sales. An Expected orders account plan is a separate order-intake target: it does not inherit sell-out scores, store coverage or a forecast interval from this engine.

Each run of the sell-out engine is a vintage, the forecast as it stood in one week. A vintage is scored against what the account later reported. A later run never rewrites an earlier score.

The three measures ​

  • WMAPE is the total miss, whichever way, divided by the total sold. 20% means the forecast was off by a fifth of the units. Lower is better.
  • Bias is the net miss divided by the total sold. The Accuracy figure's tip says forecast runs high when the forecast ran high, forecast runs low when low, and forecast runs level when it was even. Bias can be near zero while WMAPE is large, because high and low misses cancel.
  • Hit rate is the share of forecast cells whose actual sales fell inside the P10 to P90 range. A range that is honest hits about 8 times in 10.

Both WMAPE and bias are blank where nothing was sold, because there is no total to divide by. Hover or focus Accuracy on the account's forecast for N of M doors scored.

Not yet scored ​

A forecast week is scored only once it ended more than 4 weeks ago. An account's report trails the week it describes, and scoring a week whose report has not arrived would read the delay as a miss. So a new forecast shows a dash for accuracy, with one of these reasons in its tip.

ReasonMeaning
Too recent to scoreNo forecast week is old enough yet
Nothing reportedThe account sent nothing for the scorable weeks
Nothing to compareReports exist but no cell could be compared
No vintage scoredNo earlier run has been scored
Scoring not set upScoring has not been enabled for this account

An unreported week is left out and counted. It is never scored as zero. The one exception is an account that lists only the movement it had: a store it was already listing, with no row in a week it did report, counts as zero.

Reading it well ​

Look at WMAPE and bias together. High WMAPE with bias near zero means the forecast is noisy but not leaning. High WMAPE with large bias means it leans one way, and a planner can lean against it. Judge a door by its own vintages on the door page before trusting the account figure, which pools them.

Where you see it ​

On the account's sell-out forecast as the Accuracy fact, and per vintage on the door page.